These legs are specially made for our Lighthouse and Solar T5 hoods.
Approximately 2 inches long
They slide into the grooves on the sides of the hood material and can be placed anywhere along the groove.
Installation Instructions - The Leg Kit comes with two right legs (R stamped on the two right legs) and two left legs (L stamped on the left legs), four track guides and four screws.
On the front and back sides of the Lighthouse and Solar hoods is a groove that the track guide slides into. Slide one of the track guides into the groove to get proper orientation of the track guide. Place a screw through the flat side of one of the legs. Remove the track guide from the side of the light housing and place the side that was facing you against the back side of the leg. Tighten the screw into the track guide just enough to hold the leg on (if it is too tight you won't be able to slide the track guide into the groove).
For the LIGHTHOUSE hood, slide the track guide into the groove, for the SOLAR hood angle the track guide into the groove, then tighten with a Phillips screwdriver enough to hold the leg firmly in place.
Once all four legs are mounted, loosen the legs just enough so they can be adjusted to match the width of the tank. Then tighten all four legs firmly enough so they are locked into place.